Mellanox Technologies SX6720 Hardware User Manual

42, 42 Mellanox Technologies Step 1. Make sure the mating connector of the new unit is free of any dirt and/or obstacles. Step 2. Insert the power supply unit by sliding it into the opening, until a slight resistance is felt. Step 3. Continue pressing the power supply unit until it seats…

81, Rev 1.9 81Mellanox Technologies 18. Cordon d'alimentation UL Listed et certifié CSA 19. Courant de fuite élevé 20. Codes d'installation 21. Interconnexion des unités 22. Ne pas utiliser comme étagère ou plan de travail 23. Directive DEEE Pour le branchement…

48, 48 Mellanox Technologies The primary power supply (PS) unit is located on the left side, and the secondary unit is located on the right side. The power supply status LEDs on the rear side of the system are located on the PSUs themselves. Each PSU has one LED of its own 3.2.1.4 Unit Identification…

50, Mellanox Technologies SX6720 50 Mellanox Technologies Table 20 - Port LEDs in InfiniBand System Mode In InfiniBand system mode, the LED indicator, corresponding to each data port, will light orange when the physical connection is established (that is, when the unit is powered on and a cable is plugged into the port with the…

73, Rev 1.9 73Mellanox Technologies 3. 重設備 4. 有觸電的危險 5. 溫度過高 6. 堆疊機箱 7. 複式電源連接時的電擊危險 8. 雙極 / 中性保險絲 9. 多電源輸入座 10. 閃電時的電擊危險 本設備極重，應使用機械式起重機來…

54, 54 Mellanox Technologies 5 Troubleshooting 5.1 Troubleshooting Instructions Table 21 - Troubleshooting Problem Indicator Symptoms Cause and Solution LEDs System Status LED is blinking for more than 5 minutes Cause: MLNX-OS software did not boot properly and only firmware is running. Soluti…