Olsen G95V80 Installation, Operation & Maintenance Manual

39, 18  CONVERSIONS 7. Remove the manometer hose from the outlet pressure tap boss, and tighten the outlet pressure tap screw using the 3/32” Allen wrench. (clockwise, 7 in-lb minimum). 8. Turn on the gas supply and electrical power to the furnace. 9. Turn on system power and energize valv…

19, 12  VENTING GUIDELINES TABLE 6 - DIRECT AND NON-DIRECT VENT LENGTHS MAXIMUM ALLOWABLE LENGTH OF EXHAUST OR INTAKE MODEL PIPE SIZE NUMBER OF 90° ELBOWS NOTES 0123456 60 1½” 25 20 15 10 5 - - 1. Count concentric vent fi tting as straight pipe. 2. Use medium or long sweep elbow…

7, Olsen G95V80 Installation Requirements Speci c To The State Of Massachusetts For Direct Vent, Mechanical Vent, And Domestic Hot Water Appliances. For all side wall horizontally vented gas fueled equipment installed in every dwelling, building or structure used in whole or in part for residenti…

32, 15  VENT AND DRAINING OPTION  DOWNFLOW Instructions for Down ow with Left Side Venting 1. Remove 2.5” knockout and connect 2” nipple approximately 2.5” long ( eld supplied) to the coupler on the exhauster. Ensure exhauster coupler drain outlet is facing downward 15°. 2. Connect…

21, Furnace Venting Installations  e vent terminal should be located no fewer than 6 feet from an inside corner formed by two exterior walls; a 10 foot distance is recommended. Recommended clearance from overhangs is a minimum of 1 foot vertically for each foot horizontally up to 6 fe…

44, For proper furnace operation, air  ow over the heat exchanger is of utmost importance. Insu cient air ow accelerates metal fatigue and failure in the heat exchanger and excessive air ow promotes acceler- ated corrosion of the heat exchanger. NOTICE IMPORTANT: Do not bypass this step of …