Palram MiniPro Assembly Instructions Manual

39, 72 71 (A) M44 M22 M44 OUTSIDE INSIDE DOOR OUTSIDE INSIDE DOOR M19 M19 Install door handle M19 in the hole bored the in right hand side door. See inside / outside proper mounting position. INSIDE OUTSIDE M44 M52 M49 Connect parts M49 and M52 to M44 as shown in the drawing. These two item…

2, ITEM MM QTY. M19 2 M10d 6 120mm 9 M10 M9 3 A15 1290mm 2 700mm 2 A38 590mm 8 A40 1495mm 2 A14 325mm 2 1390mm 2 1435mm 1 600mm 1 P3 P4 P5 ITEM MM QTY. 2 P7 10 P6 ITEM …

29, 51 A11 590 P4 (b) (b) (a) (a) A11 590 P4 (a) (a) (b) A11 590 A11 590 (b) P4 (b) Slide two additional panels P4 (a) into corner profiles A13/1390 (one on each side), and interconnect each P4’s couple (one on each side) by inserting profile A11/590 between them (b). 52 (a) A40 1495 P4 (b)…

17, 27 28 Now, that the rear wall is nearly completed, mount the triangular panels P6 (matching the roof support structure). This is a two stages step. First, slide the outer ones (a) (note directions in the drawing) to interlock with aluminum profiles A14/325, not all the way down. (b) Slide profile…

13, 16 19 20 P4 A11 590 (a) (b) P7 A11 590 A14 1435 A14 1435 P4 P4 P3 P4 P4 P4 P3 P3 P3 (a) (b) A11 590 P7 Slide an aluminum profile A11-590 from right to left onto the upper edge of the panel P3, (a) in the drawing. Now slide the vent assembly P7 (also from right to left). ATTENTION - ensure tha…

3, Palram MiniPro (a) (b) (b) M601 M601 M606 M606 M601 M601 M603 (c) (c) click (d) M603 M604 M29 1 2 M604 The short profiles M604 are to be used in the continuing assembly for interconnecting all the rest base profiles (c). When performing this next connections step , verify that the small protruding con…