ELNA 664PRO Instruction Manual

20, ELNA 664PRO 19 Position de la barre du guide-fil Monter la barre du guide-fil aussi haut que possible. Tourner la barre du guide-fil pour que les guide- fils se trouvent juste au-dessus des broches à bobine. Barre du guide-fil Guide-fil Butées Broche à bobine * S’assurer que les deux butées de l’ar…

33, 32 Lower Looper Pre-Tension Setting Lever Standard serging (ST) Push down the lever for standard serging with 2, 3 or 4 threads Lower looper pre-tension setting lever Rolled hemming (RH) Push up the lever for rolled hemming with 2 or 3 threads. Changeable Thread Guide 3/4 thread …

43, 42 Threading the Machine The illustration shows the machine threaded with four threads. Lower looper thread Upper looper thread Right needle thread Left needle thread Thread guide Thread guide Threading chart The machine is pre-threaded to make threading easier. Tie the end of a new …

61, 60 q w u r t y e Threading the Needle with the Needle Threader The needle clamp can be tilted up for easy threading (see page 30). When rethreading, remove the thread from the needle eye before tilting up the needle clamp. IMPORTANT: When tilting up the needle clamp, be sure to: – tu…

47, 46 Threading the Lower Looper Open the looper cover. Place the spool of thread on the right side spool pin. * The points to thread for lower looper are marked in green. * A convenient threading chart is placed on the machine body inside the looper cover. 1. Draw the thread thro…