Digicom POS 360 Series Operation & User’s Manual

26, Digicom POS 360 Series 26 5.2. Replacing Mainboard & I/O Board To replace Main Board and I/O Board, please first follow the steps in chapter 5.1. a. Loosen the thumb screws (2) b. Disconnect the cables (8). IDE1 cable, HDD power cable ,MSR cable, Fan power cable, LVDS, Inverter …

29, 29 5.5. Replace Inverter Board & Touch Screen Board To replace the inverter board and touch screen board, please first follow the steps in chapter 5.1., 5.2(b), 5.3(a~d). a. Remove the screws(4) and separate the back cover from the . b. Remove the screws (2) …

5, 5 Table of Contents 1. Item Checklist ................................................................................................6 1.1. Standard Items......................................................................................6 1.2. Optional Items................…

22, 22 4. Peripherals Installation 4.1. Magnetic Card Reader Installation The MSR unit is tested and can be supplied at your request. This MSR is removed during transportation and can be connected by the user. There are two types of MSR Module: RS232 type and keyboard …

38, 38 RJ45_2: COM1, COM2, COM3, COM4 Pin 21 N/C Pin 22 RS232_3_DCD# Pin 23 RS232_3_DSR# Pin 24 RS232_3_RX# Pin 25 RS232_3_RTS# Pin 26 RS232_3_TX# Pin 27 RS232_3_CTS# Pin 28 RS232_3_DTR# Pin 29 GND Pin 30 RS232_3_RI Pin 31 N/C Pin 32 RS232_4…

19, 19 e. Click the “Next” button on the “Select Program Folder” window. f. Click the “Finish” button on the “Install Shield Wizard Complete” window. g. Click the “Continue Anyway “ button on the “Hardware Installation” window. …