Dinstar MTG1000 Operation & User’s Manual

22, Dinstar MTG1000 MTG1000(B) Trunk gateway User Manual 18 / 76 SS7 is a standard protocol to initiate a calling connection with SPC exchange. Notes: 1. “Trunk No.” is a shared data, therefore, SS7 „Trunk No.‟ can't be the same as PRI “Trunk No.” 2. SPC length is…

35, MTG1000(B) Trunk gateway User Manual 31 / 76 Trunk Name Description the trunk Remote Address IP address of remote platform interfacing with this equipment. Remote Port SIP port of remote platform interfacing with this equipment, the default is 5060 Outbound Proxy SIP p…

55, MTG1000(B) Trunk gateway User Manual 51 / 76 2.15.6 Firmware Upload Figure 2-14-7 Firmware Upload Firmware upload description Software Click "Browse" to select the firmware, and then click "Upload". Web Click "Browse" to select the Web s…

33, MTG1000(B) Trunk gateway User Manual 29 / 76 Figure 2-7-10 PSTN Group Add Adding PSTN group needs to fill three parameters: trunk group Numbers, trunk group Name. Channel selection mode and at most, can add up to 16 set of data. Channel selection mode refers to E1/T1 tim…

67, MTG1000(B) Trunk gateway User Manual 63 / 76 EIS(ada)#[153-14:19:20:680]ST: <5,Ss7,65535,65535,,active> <<== CC_DISCONNECT_IND, q931id:773, if:2, calling:, called: org_called:, e1:10, ts:5, callingTyp:0, calledTyp:0, presentationInd:0, send_ok:0, cause:16(正常的呼叫…

4, MTG1000(B) Trunk gateway User Manual 2.8.1 SIP Parameter ......................................................................................................... 30 2.8.2 SIP Trunk .............................................................................................…