AOR SDU5600 Operating Manual

46, AOR SDU5600 46 Command : WUBE Function : BEEP SETTING Command category: WRITE Parameter : 1 ~ 7 Example : WUBE6<CR><LF> Response: if correct: <SP><CR><LF> if incorrect: ?<CR><LF> Remarks: Parameter: 1 = Emit “click” when key is pressed. 2 = Emit “click�…

35, 35 6-3 Monitor the FM broadcast band in the step resolution mode The following information explains how to change the monitoring mode from the default of spectrum analyser mode to the step resolution mode. Press the FUNC + 2 (STEP), the SDU5600 will shift to Step Resolution mode wi…

36, 36 6-4 Monitor the VHF air band in the channel scope mode. The VHF airband is allocated over the wide frequency band, It is therefore impossible to display the entire VHF airband on the SDU5600 at once. The channel scope mode however provides a very convenient method of monitoring the chann…

11, 11 2 Connection 2-1 Connection with the power supply Where possible, use the supplied AC/DC power unit. Make sure the main switch of the SDU5600 is in the OFF position before connecting the power supply. 2-2 Connection with the receiver This hand book is compiled mainly referring to…

14, 14 4-2 Display This section explains what you can expect to see on the SDU5600’s monitor screen using Spectrum Mode as a typical example. The screen will appear differently when switched to other operating modes. (1) Centre frequency - CF: The centre frequency reading is shown in MHz…

3, 3 Index Index Safety notices ................................................................................................. 5 SDU5600 brief circuit description .................................................................... 6 LCD resolution ........................................…