AOR AR3030 Operating Manual

28, AR3030 operating manual 27 The currently selected VFO is indicated on the LCD by [A] or [B]. To change from one to another simply press the [VFO] key. To return to the original VFO press the [VFO] key again. Note: The rotary tuning control is also often historically referred to as the V…

25, AR3030 operating manual 24 6-1 Tuning the receiver using the rotary control The receiver may be immediately tuned via the rotary tuning control. The free running tuning knob is used to select receiving frequency and in memory mode for selection of memory channel. The tuning knob is by far th…

33, AOR AR3030 AR3030 operating manual 32 Correcting frequency input errors via the keypad Should you make a mistake when entering a frequency via the keypad there are two methods of correction. Back Space delete The [ENT/BS] key acts as a “BS” Back Space just like a computer keyboard deleting data …

9, AR3030 operating manual 8 (4) Precautions 4-1 Location Do not use or leave the receiver in direct sunlight. It is best to avoid locations where excessive heat, humidity, dust and vibration are expected. Always treat the receiver with care. Take care to avoid spillage or leakage of li…

45, AR3030 operating manual 44 0 B [CR] - Selection of FILTER NORMAL 1 B [CR] NARROW 0 T [CR] - Selection of TONE LOW 1 T [CR] HIGH nnn.nnnn [CR] - Enter the frequency (MHz) and go to the dial (VFO) mode. Frequency entry for MHz band must be correct within the range of receiver. Over-flow digi…