ESAB Powercut 900 Instruction Manual

9, - 9 - bp17ea 4.2 Mains power supply Make sure that the power source is connected to the correct supply voltage and that it is protected by the correct fuse rating. The outlet shall have a protectiv earth connection. Rating plate with supply connection data Recommended fuse sizes…

11, - 11 - bp17ea 4.5 Connection of torch Open the lid on the front panel. Connect the torch cable receptacle to the panel receptacle. Check the orientation of the sockets to ensure a correct fit. Connect the air hose to the quick-connect fitting. Place the strain relief in the square cut…

14, - 14 - bp17ea Torch trigger/Gas test switch - (4) Operating modes: Normal trigger (CENTER position) - Setting will be used for most cutting and gouging operations. The torch switch must be held in by the operator during the entire cutting operation and then released at the end of cut. Recommende…

4, - 4 - bp17ea 1 SAFETY Users of ESAB equipment have the ultimate responsibility for ensuring that anyone who works on or near the equipment observes all the relevant safety precautions. Safety precautions must meet the requirements that apply to this type of equipment. The following r…

5, ESAB Powercut 900 - 5 - bp17ea WARNING Read and understand the instruction manual before installing or operating. Arc welding and cutting can be injurious to yourself and others. Take precausions when welding and cutting. Ask for your employer's safety practices which should be based on manu…