Dynaflite super decathlon Instruction Manual

20, ASSEMBLE THE FUSELAGE ❏ 1. Pin the die-cut 1/8" ply fuse bottom in place on the top view plans. Note: Make sure the slot in the front of the fuse bottom matches the plan. This slot helps set the right thrust. ❏ 2. Fit the fuse sides, bulkhead 3A and bulkhead 4 in place. Use a squa…

18, Dynaflite super decathlon ❏ 7. Remove the engine and mount from the firewall. Using your rotary tool, make clearance holes in the firewall for the engine mounting bolts and washers. ❏ 8. Re-attach the engine and mount to the firewall. ❏ 9. Make a mark on the engine mount for the throttle pushrod.…

33, 33 BALANCE THE MODEL LATERALLY Do not confuse this procedure with “checking the C.G.” which will be discussed later in the manual. Now that the model is covered and nearly completed, this is the time to balance it laterally (side-to-side). Here’s how: ❏ 1. With the w…

12, ❏ ❏ ❏ ❏ 3. Using a square to properly align the sheeting with the trailing edge of the wing as shown on the plans, position the sheeting and glue it in place. DO NOT align with the trailing edge of the ribs. (See the cross section of the plans.) ❏ ❏ ❏ ❏ 4. Ed…

31, 31 FINISH THE WINDSHIELD AND COWL ❏ 1. Trim the windshield along the cut-lines and test fit it to the cabin. Trim where necessary for a good fit. Tack glue the windshield in place. Note: The windshield will be permanently attached to the fuse after the model is covered. ❏ 2. M…

30, ❏ ❏ 6. Mount the wing to the fuselage. Screw one of the 6-32 x 1-1/2" studs all the way into one of the nylon strut ends. Mount the strut end (and stud) in the forward hole in the wing. ❏ ❏ 7. Align the strut overlapping the strut end. Make a mark on the strut at the …