Fiio X3 Operation & User’s Manual

9, 1. When switching between songs of different sample rates, there will be a slight pop sound. This is caused by the WM8740 changing its system clock. 2. When you change TTPlayer's output device from wave out to KS (kernel streaming), it may show a “cannot open” error. Please …

8, 8 4. Operating instructions Key functions: Previous / down and Next / up : In USB DAC mode, these two buttons are used to select between the 5 options in the DAC interface. Menu / back :no function…

3, 3 1. Items to prepare before driver installation: The X3, a TF card (microSD card), the computer, USB cable, ASIO driver and the firmware provided with this article. 2. Precautions: 1. For desktop computers, connect the X3 to a USB port on the rear of the case, not the front. This is b…

5, Fiio X3 5 2. After upgrade is complete, a USB mode will be added to the X3's system settings menu: DAC mode. This is the new default. The other mode is mass storage mode (the old mode). 3. After confirming that the USB mode is “DAC”, connect the X3's micro USB port to the computer&ap…

4, 4 Mouse over upper right corner of screen->settings->Change PC settings->General-> Advanced->start-up->Restart now->Troubleshoot->Advanced options->Start-up Settings->Restart htt p :// bs. cbeta. om/ iew t h r e a d - 122 7 2 0 - - . tm l htt p :// bs. cbeta. o…

7, 7 The above dialog will pop up indicating successful installation of the driver. Click Next. Click Finish to complete installation. Icon would appear at the bottom right corner: After installed the driver, set “FiiO X3” as the default audio play device. (Control panel>Sound>Pl…