Jetview JE-900 series Operation Manualr

11, IV、 Protocol, Baud Rate and Camera ID setup It is important to know how to setup the protocol, baud rate and camera, the camera can be controlled by controller that is both of them with same protocol, baud rate and camera ID 4-1 For the low speed series(JE900L) There are two Dip-sw…

9, Connection sketch for Alarm input with Usual-open detector How to operate alarm function Step 1: Setup at alarm preset positions. Setup preset position 1 for alarm 1 Setup preset position 2 for alarm 2 Setup preset position 3 for alarm 3 Setup preset position 4 for alarm 4 …

6, The code 140, 141, 142 is special for setup and run a tour group “142” + “PREVIEW” key for command the camera to tour. “140” + “PREVIEW” key for programming a tour group. “141” + “PREVIEW” key for exiting the setup. For Example, Program a tour in order…

7,  For low speed dome camera(JE900L series) a. Key “160 + PREVIEW” key to activate the function for setup of left/right limited positions b. Control the dome camera by joystick, moves it to the right direction and reaches the desired point as a right limiting position, th…

2, I、 Connecting diagram 1-1 For the high speed dome camera with alarm function (JE-900H) 1-2 For the low spped dome camera without alarm function (JE-900L, IR800) …

10, Jetview JE-900 series Enter “147+ preview” on keyboard controller to enable the alarm function, Enter number “148+ preview” on keyboard controller to disable the alarm function, Attention: a. Alarm input must be ON/OFF input signal, any other type of input signal (such as power voltage etc) is possible …