Jimi JV200 Operation & User’s Manual

17, 6.2 Check location 1. Via SMS 1.1 SMS “WHERE#” to the SIM number of device. The device will send a location message automatically. You can get the coordinates. If the device does not search any information of location, it will send “No data” to the cell …

8, Make sure there is enough credit on the SIM card. If you will be using the GPRS function, you should pay attention to the current SIM card GPRS charge. 4.2 Charge the device (Covert installation) Plug the device connector into a charging cable. The charging cable with 2A FUSE for short-c…

21, When the alarm is off, sending recover oil commands manually. Device will restore oil supplying, and vehicle will work normally again. Platform account password is needed when sending oil cut off command. 2. Via SMS Only center number can send the command to the device to restore oil. The format…

12, 5.1 Add SOS number SMS command to the device to add the SOS number. SOS,A,No.1,No.2,No.3# “A” means to add new numbers, for example: SOS,A, 18165542975, 18165542976, 18165542977# It will reply “OK! SOS1: 18165542975 SOS2: 18165542976 SOS3: 18165542977” after set successful…

13, Command format: SERVER,1,domain,Port,0# Example: SERVER,1,www.jimishare.com,8841,0# It will reply “OK” after set successfully. 5.4 Set the center number If you want to cut off/restore oil by SMS command, you have to set a center number rstly. Only the center number can send the cut o…

7, Jimi JV200 4. Getting Started Get started by assembling and setting up your device for its rst use. To remove the back cover: ● Firmly hold the device with both hands and the front panel facing down. ● Push the back cover up with your thumbs until it disengages from the device an…