Kaba E-PLEX 2000 Installation Instructions Manual

21, 21 B-3. Additional steps for Autodeadbolt ASM inside trim assembly If not already installed at the factory, put the thumbturn in the vertical position and install all four (4) parts (M) as shown, on the inside trim assembly. Turn the thumbturn all the way to the right for a RH installation …

2, Kaba E-PLEX 2000 TABLE OF CONTENTS A. Cylindrical Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 B. Mortise Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10 C. Exit Trim Installat…

38, 36 D. INSTALLING OUTSIDE LEVER ON NON-MECHANICAL OVERRIDE Assemble the lever on the outside housing in the hori- zontal rest position appropriate to the handing of the door. Simply push the lever onto the tube until it clicks in place. If more force is required, use a rubber mallet. Test …

39, 37 F. INSTALLING OPTIONAL K-I-L KEY OR BEST REMOVABLE CORE OVERRIDE AND OUTSIDE LEVER Important: Assemble the lever, cylinder and lock components before affixing the entire unit to the door. F-1 Upon unpacking, the lock housing with mechanical override should look like the diagram below with: •…

36, J K 34 C-3. INSTALL THE LOCK AND EXIT DEVICE 1. Install the Mortise (if applicable) For mortise exit devices, install the mortise according to the manufacturer’s instructions 2. Install the Outside Lever Assemble the lever on the outside housing, in the horizontal rest position appro…