La Crosse Technology WS-8418U-IT Instruction Manual

2, Get Started Step 1: Insert 2 fresh AA, batteries into the TX37U-IT sensor according to the polarity marked in the battery compartment. Step 2: Insert 2 fresh AA, batteries into the atomic clock according to the polarity markings. Step 3: After 5 minutes …

5, Specifications Care and Maintenance • Do not mix old and new batteries • Do not mix Alkaline, Standard, Lithium or Rechargeable Batteries • Always purchase the correct size and grade of battery most suitable for the intended use. • Replace all batteries of a set at the same t…

3, 7. Weekday 8. 12/24 Hour Format 9. Fahrenheit/Celsius Press SET to exit, or wait 15 seconds without pressing buttons to return to the normal time display. Set Alarm Time 1. Hold ALM to enter ALM set mode. 2. Press + to adjust values. 3. Press ALM to confirm adjustments and move t…

4, WWVB Radio-controlled Time • WWVB Icon will flash when searching. • The WWVB icon will be steady when time signal received in the past 24 hours. For information about WWVB visit: www.nist.gov/pml/div688/grp40/wwvb.cfm ATOMIC SIGNAL SEARCH: The atomic clock will search…

1, La Crosse Technology WS-8418U-IT Model: WS-8418U-IT Instruction Manual! DC: 062915 ATOMIC WALL CLOCK With Moon Phase and IN/OUT Temperature WS-8418U-IT www.lacrossetechnology.com/support Page | ! 1 Time, Alarm, + WWVB Icon Foldout Stands Indoor Temp, Month, Dat…

7, This device must not be co-located or operating in conjunction with any other antenna or transmitter. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interferen…