Johnson & Starley SCT 75-75 G Installation And User Instructions Manual

7, 7 It is the aim of the T.R.S. to prevent flue gasses from the water heater entering the room where the water heater has been placed, instead of passing through the flue to outside atmosphere. The thermo-couple circuit is interrupted and the gas supply is disconnected as soon as the T.R.S…

17, 17 Procedure: 1. Close the main gas tap in the gas sup- ply; 2. Demount the burner (see “Cleaning”); 3. Replace the injector of the main burner and the pilot burner with the correct injectors from the conversion set (see table above); 4a. Conversion from natural gas to LP- ga…

2, 2 Read these installation instructions first before installing the appliance. Carefully read the user instructions before igniting the appliance. Failure to follow these instructions may lead to risk of explosion and/or fire and could cause material damage and/or bodily harm. Installation and comm…

13, 13 2.1.4 Flue system The water heater should be fitted with a flue system connected to the draught diverter. The flue pipe should rise for at least 50 cm. vertically before the inclusion of any bends. If a horizontal run of flue is required this should be kept to the minimum length …

22, Johnson & Starley SCT 75-75 G 22 Failure Cause Measure 3.4 Fault finding Blocked pilot burner Blocked chimney Safety thermostat Thermocouple defective Thermocouple makes no contact Gas supply closed Temperature is set too low Control knob in position (✸) (pilot burns ) Control knob in position (●) Flue safety de…