Aquacal HP7 Operating/service Instructions Manual

10, 10 5) With [ELC] displayed, use the Up or Down arrow keys to select a lock code number. The factory set lock code is “17”. Not depressing any buttons for 15- seconds will allow the control to save the selection and return to the normal operating mode. Pressing the Pool / Sp…

5, Control Features: ♦ Compressor Operation ♦ Refrigerant Circuit Hi & Low-Pressure Lock Out ♦ Water Pump Option (Call Flex) ♦ Precise Evaporator Temperature Control (Defrost Management) ♦ Anti Short Cycle Timer (4-Minute Restart Delay) ♦ Precise Water Temper…

21, WARNING !!!! Dealer & Service Center Use Only Warning ! MAKE CERTAIN POWER SUPPLY TO HEATPUMP and CONTROLLER IS DISCONNECTED PRIOR TO CONTINIUING. FAILURE TO DISCONNECT ELECTRICAL POWER MAY RESULT IN SERIOUS INJURY OR DEATH. 1. String 18/3 cable from the controller to the heat…

11, 11 10. Fan Speed Control… This option is not applicable to any current models. If option present, factory default setting of “80” MUST remain. Controllers Version .06 or newer will not contain a FAN option. LEVEL-1 DISPLAY CODES Menu Codes Descripti…

1, Operating & Service Instructions -for- HP7 Microprocessor Controller Includes Connection of External Controllers Dealer & Service Version Not for Distribution to Owners 2737 24 th Street North St. Peters…

18, Aquacal HP7 WARNING !!!! Dealer & Service Center Use Only APPENDIX Connecting to, and Configuring Microprocessor for, External Control: • A: Jandy and Pentair/Compool Brand External Controllers Equipped with an “OFF” Position • B: External Controllers NOT Equi…