Hobie Twixxy Assembly Manual

16, • 16 Using the straps and clips on the leech of the mainsail, secure each batten into it’s respective pocket (as per photograph). Push the bat- tens in reasonably hard - sufficient to remove any wrinkles from the pocket. NOTE : it is important to relieve the tension on the batten…

18, • 18 Attach the jib clew blocks to the clew of the jib using the snap hook provided. 3 Thread the jib sheet line through the jib sheet blocks. Fasten the sheet to the top of the blocks using a bowline knot. Ensure that there are no twists in the sheet and that the sheet is led beh…

17, • 17 Unfold the jib and shackle the head onto the jib halyard with the shackle provided. Fasten the clip at the top of the jib to the forestay wire. Pull on the halyard and raise the sail, fastening each clip to the forestay in the process. When the sail is raised, shackle the tack…

22, • 22 SPINNAKER (Option) Attaching the spi pole Fix the base of the pole onto the spi pole connection fitting in the centre of the front cross beam. 1 Bridles Next, attach the two bridle wires to each side of the bows of the boat with…

1, • 1 ASSEMBLY MANUAL HOBIE CAT EUROPE ZI Toulon Est, BP 250 83078 Toulon cedex 9, France Tel : +33 (0)494 08 78 78 - Fax : +33 (0)494 08 13 99 Email : [email protected] - http://www.hobie-cat.net …

13, Hobie Twixxy • 13 At this stage, if you have a spinnaker kit, also attach the spi ratchet block with plastic spring as shown on the picture PREPARATION OF THE MAST Using a bowline knot secure the jib ha- lyard line to the small block on the end of the jib halyard wire. Now secure both ends at the base …