Imperx IPX-VGA120-L Operation & User’s Manual

143, LYNX Manual RA02 Figure C.3 – Serial Transport Properties dialog If you have selected ‘Serial Transport’, then you must choose the COM port in the Serial pull-down menu and configure its operating parameters ( i.e. ‘Bits per’, ‘ Data Bits’, etc. ). ww…

110, LYNX Manual RA02 3.8.14 Test Pattern generation 3.8.14.1 Set Test Mode ( ‘gtm’) The ‘stm’ command instructs the camera to enter a test mode and deliver a test pattern to the Camera Link interface. This command is useful during frame grabber configuration and when t…

82, LYNX Manual RA02 2.12 NEGATIVE IMAGE When operating in the negative image mode, the value of each pixel is inverted. The resultant image appears negative – Figure 2.54. This feature could be useful if the camera receives a negative image (i.e. image from microfilms, prints or…

114, LYNX Manual RA02 3.8.16.7 Set Pre-Exposure ( ‘spe’) The ‘spe’ command sets the exposure time for the first frame after a trigger event when the trigger is in the ‘standard’ mode.. The first frame after a trigger will be exposed for the length of time specified. All subsequent…

136, LYNX Manual RA02 Appendix B – Lynx Configurator Lynx Configurator This appendix provides a quick reference to using the Lynx camera configuration utility. www.imperx.com 136 of 154 5/6/2005 …

120, Imperx IPX-VGA120-L LYNX Manual RA02 3.8.20 Current Speed and Exposure 3.8.20.1 Get Camera Speed ( ‘gcs’) The ‘gcs’ command returns the measured operating speed ( frame rate ) of the camera. The current operating speed is determined by a number of settings ( see note below ). The camera is capab…