GREAT PLANES Extra 300S ARF Instruction Manual

11, ❏ ❏ 16. Find the four white nylon anti-rotation pins. Locate the holes in the wings for the pins. Mix a small amount of 30-minute epoxy and glue the anti-rotation pins in place. Once inserted the pins should stick out about 1/2" [13mm]. Clean up any excess epoxy with a paper towel dampened…

34, GREAT PLANES Extra 300S ARF will need to be throttle conscious; that is, never apply full throttle on straight and level flying or in dives to prevent flutter. The large control throws require servos with great centering. The digital servos are second to none in this department. Digital servos such as the Futaba S9250 (F…

7, 7 1. Fuselage & Canopy 2. Stab Center Section 3. Right Stab Half and Elevator 4. Left Stab Half and Elevator 5. Aluminum Stab Mounting Tubes 6. Left Wing and Aileron 7. (4) Ply Wheel Pant Mounts 8. (4) Ply Wing Washers 9. (5) Hardwood Cowl Blocks 10. (8) 4-40 x 12" Metal Pushrod…

36, off the controls. The model should go a reasonable distance with the fuse at an even keel. If the nose pitches down, remove some nose weight, and the opposite if the nose pitches up. The trick is to use only the ailerons to get the model up at a 45° bank. We almost automatically start fee…

12, Once the glue has cured, install the servo tray in place as shown using 6-minute epoxy. The notched side fits against the former. ❏ 1.Top and bottom firewall support: Make marks 1/8" [3.2mm] away from the edge of the firewall at the center of the firewall support lip and 3/4"…

5, In addition to common household tools and hobby tools, this is the “short list” of the most important items required to build the Extra 300S ARF. Great Planes Pro ™ CA and Epoxy glue are recommended. ❏ Top Flite ® MonoKote ® sealing iron (TOPR2100) ❏ Top Flite Panel Line P…