Harley Benton LP-Style Owner's Manual

4, Harley Benton E-Guitar Kit LP-Style 4 Body finish The rst consideration to be made before assembling is to choose the preferred nish of the guitar body. The basswood body of the guitar is sealed and prepared for various types of lacquer coating. A wide variety of nishes can be procured…

10, Harley Benton E-Guitar Kit LP-Style 10 Wiring Connect the switch with the three cables coming from the control cavity according to the marking numbers located on the connectors. Put the switch on the right position and x it from the front side. The rear body plastic plates now can be tted to…

7, www.thomann.de Harley Benton E-Guitar Kit LP-Style 7 Wiring Then put the potentiometers on the right positions as shown in the following picture. The Tone and Volume potentiometers on the downside should be connected to the neck pickup. The Tone and Volume potentiometer on the upper side …

11, Harley Benton LP-Style www.thomann.de Harley Benton E-Guitar Kit LP-Style 11 Wiring Now you can x the pickguard. This is very simple, just do it according to the following pictures. …

3, www.thomann.de Harley Benton E-Guitar Kit LP-Style 3 Introduction Thank you for buying the guitar kit. All the wood, hardware and electrical components of the guitar are contained in this package. Please read the following instructions for assembly and nishing. …

6, Harley Benton E-Guitar Kit LP-Style 6 Neck With the body placed face up on a protective surface, position the neck into the neck cutout until it is fully inserted. Turn the assembly over and position the neck plate (with its black protective seal) over the four bolt holes at the rear of the…