Ariens Hydro Pro Track 32 Manual 

8, EN - 8 EMISSION CONTROL SYSTEM This equipment and/or its engine may include exhaust and evaporative emissions control system components required to meet U.S. Environmental Protection Agency (EPA) and/or California Air Resources Board (CARB) regulations. Tampering with emission controls and…

33, EN - 33 7. Remove attachment drive belts from engine sheave (it may be necessary to turn engine sheave using recoil starter handle). IMPORTANT: To avoid bending bottom cover when tipping unit apart, support handlebars firmly or tip unit up on housing and remove bottom cover by removing six cap…

22, EN - 22 5. Check Engine Fuel & Crankcase Oil Check and add fuel if required. Check that the engine crankcase oil is full using dipstick. Refer to Engine Manual for detailed instructions. TO STOP IN AN EMERGENCY Immediately release both control levers to stop unit in an emergency.…

9, EN - 9 Understand: • How to operate all controls. • The functions of all controls. • How to STOP in an emergency. Before starting engine, disengage control(s). Use only approved extension cords and receptacles when starting units equipped with electric starter. DO NOT connect electric st…

23, Ariens Hydro Pro Track 32 EN - 23 NOTE: A warm engine requires less choking than a cold engine. 5. Set throttle to proper starting position. 6. Turn ignition key to the START position until engine starts and release into the RUN position. IMPORTANT: DO NOT operate starter more than 15 seconds per minute, as ov…

31, EN - 31 5. With the attachment clutch disengaged, check that the attachment idler arm lightly touches the frame (Figure 26). 6. Tighten jam nut on the adjustment barrel. \ Check Attachment Idler Arm Roller Clearance (Figure 27) NOTE: It will be difficult to check the measurement inside the …