Glow-worm Envirosorb3 Installation Instructions Manual

35, Glow-worm Envirosorb3 Appendix 0020154078_03 Envirosorb₃ Installation instructions 35 Code Meaning 9 Heating mode: Start command for the compressor 10 Product in heating mode 11 Product in hot water handling mode 12 Heating mode: Water temperature exceeded 13 Hot water handling mode: Water temperature exceeded …

34, Appendix 34 Installation instructions Envirosorb₃ 0020154078_03 Technical data – Coolant circuit Envirosorb 3 5 Envirosorb 3 8 Envirosorb 3 11-1 ph Envirosorb 3 15-1 ph Coolant type R410A R410A R410A R410A Coolant contents 1.80 kg 1.95 kg 3.53 kg 4.40 kg Maximum permissible op…

15, Assembly and installation 5 0020154078_03 Envirosorb₃ Installation instructions 15 – Maximum length: ≤ 8 mm 2. Align the product horizontally so that condensate can flow. Note The product must be installed with the vi- bration-isolating feet supplied. The product is lifted by…

26, 8 Troubleshooting 26 Installation instructions Envirosorb₃ 0020154078_03 1 2 3 1. Remove the side casing. (→ Page 14) 2. Remove both screws (1). 3. Lift off the cover. 4. Remove the four screws (2) and remove the mesh (3). 5. Clean the product. 7.6 Draining the product Conditions: SW10 …

25, Maintenance 7 0020154078_03 Envirosorb₃ Installation instructions 25 7.3 Instructions before carrying out maintenance work Observe the basic safety rules before carrying out mainten- ance work or installing spare parts. Danger! Risk of injury due to unauthorised access to the coolant circuit. E…