IKUSI HTL-STC Operation & User’s Manual

10, 11 4.3 Step 3: Output channel configuration This screen allows to select the output RF channels where the contents will be transmitted. Setup wizard shows a frequency plan with all the available channels. By default, setup wizard proposes the lowest channels. To change that sele…

29, IKUSI HTL-STC 30 This tab allow to access to the information of the CAM. The following infomation related to each CAM is displayed: NAME: Identification of the module in which the CAM is inserted. MODEL: Model of the module in which the CAM is inserted. MAX ALLOWED PIDs: Maximum number of services and e…

6, 7 3.2 Definition of the master module Communication with the headend takes place based on the definition of a module as a master and the others as slaves. By default, all the modules are slaves. The first step consists on converting one of the modules in master. Control and access t…

7, 8 By default, the language of the web interface is the same than the one used by the browser. If you want to change it, choose in the icon, the flag related with the desired language. Enter the folowing data, User: Admin Password: admin. Push Accept button. A window as the following…

20, 21 When the process ends, the configuration will be stored in the modules and setup wizard will go to step 9. 4.9 Step 9: Confirmation of the new service configuration In the final step, a summarize window will be displayed, with a list of the services that forms the selected ch…

40, Paseo Miramón, 170 20014 San Sebastián Gipuzkoa, España Tel.: +34 943 44 89 44 Fax: +34 943 44 88 20 [email protected] www.ikusi.tv …