Dynalab DB-3-200-01 Operating Manual

5, 5 Figure1A. Figure1B. Removing Tool 2. Plug the power cord to the source, and make sure that the plug is firmly pressed. Turn on the machine by switching the on/off switch (see Figure 2). Figure 2: The rear view of the Block Heater. 1, on/off switch; 2, IEC power inlet; …

7, 7 Calibration The digital types of Block Heaters can easily be calibrated to show any blocks/vials and tubes’ temperature in the displayed LED. Due to the differences in the mass of the various aluminum blocks, environmental air temperature, thermal radiation, and many o…

8, 8 process interrupted between stage 4 and 5, then the machine will take the previous 4 points data as the calibrated value, and becomes 4-points calibration. 7. During calibration, the calibration set point could not be changed unless interrupting the process by pressing the �…

4, 4 Operation of Analog Unit 1. Select the appropriate block. Make certain that the block is clean on all sides as well as the hot plate of the unit. This will ensure proper heat conduction. 2. Place the block into the well of the unit and insert the proper tubes into the block. Make …

1, Dynalab DB-3-200-01 1 BLOCK HEATER – MODELS DB-3-200-01, DB-3-130-01, DB-2-130-01, DB-2-200-01, DB-2-200-02, DB-1-130-01 and DB-1-200-01 OPERATING MANUAL VERSION 3.11 Dynalab Corp., Inc. November 2017 v1.0 …