Endace DAG 6.1S Operation & User’s Manual

27, EDM 01-11v8 DAG 6.1S Card User Guide ©2005 22 Version 8: May 2006 4.7 Inspect 10G Ethernet Interface Statistics , continued Correct configuration In order to correct the configuration, proceed as follows: • Ensure RAI, RLE and RPA (first three columns) are zero, check …

43, EDM 01-11v8 DAG 6.1S Card User Guide ©2005 38 Version 8: May 2006 7.1 Data Formats , continued Table Table 7-3 shows the Type 2 Ethernet variable length record. The diagram is not to scale. timestamp timestamp type:2 flags rlen lctr wlen offset pad rlen-1…

6, EDM 01-11v8 DAG 6.1S Card User Guide ©2005 1 Version 8: May 2006 1.0 PREFACE Introduction The installation of the Endace DAG 6.1S card on a PC begins with installing the operating system and the Endace software. This is followed by fitting the card and connecting the por…

19, EDM 01-11v8 DAG 6.1S Card User Guide ©2005 14 Version 8: May 2006 4.4 dagsix Utility Description The dagsix utility supports configuration status and physical layer interface statistics for DAG 6 series cards. In a troubleshooting configuration options –si should be passed t…

35, Endace DAG 6.1S EDM 01-11v8 DAG 6.1S Card User Guide ©2005 30 Version 8: May 2006 6.2 Time Synchronization Configurations Description The DUCK is very flexible, and can be used in several ways, with or without an external time reference source. The use includes a single card with no refe…

44, EDM 01-11v8 DAG 6.1S Card User Guide ©2005 39 Version 8: May 2006 7.2 Timestamps , continued Example code Here is some example code showing how a 64-bit ERF timestamp (erfts) can be converted into a struct timeval representation (tv). unsigned long long lts; struct timeval tv…