Encision EM3 AEM Operation & User’s Manual

44, Technical Specifications EM3 AEM User’s Guide 7-7 Recommended separation distances between portable and mobile RF communications equipment and the Model EM3 series AEM Monitor and accessories (EN 60601-1-2) The Model EM3 series AEM Monitor and accessories are intended for use in an el…

9, Foreword EM3 AEM Monitor User’s Guide v Electromagnetic Compatibility (EMC) Hazards For EMC specification tables, refer to Section 7, Technical Specifications. CAUTION  Use of accessories, transducers, and cables other than those specified, with the exception of transducers …

41, Technical Specifications 7-4 EM3 AEM User’s Guide Maximum Generator Voltage 4.5 KVpeak Electrical Characteristics Input Power Requirements 100 - 240 V~ nominal rated voltage 50 / 60 Hz Nominal current 0.2 A Maximum current 0.5 A Chassis Source Leakage Current 200 µA maximum Patient…

17, EM3 AEM Monitor User’s Guide 3-1 3 System Setup This section describes how to set up the AEM Monitoring System, turn it on, connect accessories, and perform system checks. WARNING Fire Hazard. Do not use extension cords. Electric Shock Hazard. Connect the power cord to …

19, Encision EM3 AEM System Setup EM3 AEM Monitor User’s Guide 3-3 procedure. If the monitor power is left on between procedures, press the Reset button to initiate the POST function. During POST, all of the visual indicators illuminate and two beeps are heard. If this is not the case, see Section 4 System Mai…

40, Technical Specifications EM3 AEM User’s Guide 7-3 Connectors and Cables AEM Cord/Cable Connects the AEM Instrument active conductor to the electrosurgical generator and shield conductors to the AEM Monitor, both via the Monopolar Adapter. Length: 9.5’ (2.9 m) standard disposable…