EMUS BMS Mini Operation & User’s Manual

7, 2 Setting up the BMS 2.1 Battery cells installation There are two dedicated connectors for battery pack’s power terminals and two for direct connection with batteries. In order to safely connect batteries follow these instructions step by step. Also please refer to the wiring diagram in �…

15, 3 Core BMS functionality 3.1 Battery Monitoring 3.1.1 Voltage Monitoring Battery cell voltage can be measured from 1.000 V to 4.500 V. Before final evaluation each battery cell is simultaneously sampled 32 times with a precision of 3 digits after decimal point in order to get the most pr…

16, In order to install external current sensor connect it to LIN / CAN Bus connector. If direct connection is not possible, a LIN / CAN Bus splitter should be used in order to interconnect additional bus node. 3.1.3 Temperature measurement External temperature sensors are able to measure tempera…

20, to persist for as long as the corresponding "Deactivation Delay" parameter value for the protection to be deactivated. When Enable deactivation is activated, this protection will not recover even if its recovery conditions are met, therefore protection must be reset manually…

29, EMUS BMS Mini 7 Status Parameters Main BMS monitoring statuses and states are grouped into 4 groups. Each of the groups are described in the following lists. Battery group: • State of Charge — indicates remaining charge in the battery pack. Measured in %. • Energy Left — remaining energy in the batte…