EMIT MTR4 Operation & User’s Manual

1, USER MANUAL EMIT MINI TIME RECORDER VERSION 4 AND THERMAL PRINTER (c) Emit 28.sep 2004, rev 3 Emit AS Tel: +47 22 91 03 00 Bank: 6011.05.80439 Bedriftsvn. 10 Fax: +47 22 91 03 01 WEB: www.emit.no N-0950 OSLO E-mail: [email protected] Reg.no: 930127868 …

2, The Emit Mini Time Recorder version 4 (MTR4) is especially developed for use together with our Electronic Punching and Timing system (EPT) when using “electronic timing”, i.e. when the runner’s total time is to be recorded by the electronic card carried by each participant. MTR4 has…

3, PRINTER OPERATION Printing with Martel MCP9810 In order to print with MTR4 using the Martel printer the supplied printer cable is used. Connect the end of the cable marked "EPR3" to the 9-pins D-SUB connector on the Martel printer. Connect the other end marked "MTR4 'B'&…

4, Low-power controls. When controls have week batteries, they insert a "99-code" just before their control number. The MTR4 prints this 99-control number as an ordinary control just after the control with low battery. The control- counter in the first field of the printout will in su…

5, EMIT MTR4 The protocol of the printer was correctly set when the printer left EMIT. If the protocol has been changed, it can be reset to the correct reading by following this procedure. If in doubt, you can at any moment turn the printer off in an on to start over without storing modifications. Th…

6, Environment The MTR4 is not waterproof. Beware not to expose the connectors on the upside of the MTR4 to water. It will work fine in temperatures down to minus 20 degrees Celsius (the thermal printer however is not designed to tolerate water or temperatures below 0 degrees). …