Gardner Bender B2000 Cyclone Manual, Instruction Sheet

1, RPS-0097 01/06 Effective for models with serial numbers beginning with “J”. Instruction Sheet B2000 Cyclone ® Bender IMPORTANT RECEIVING INSTRUCTIONS Visually inspect all components for shipping damage. If shipping damage is found, notify carrier at once. Shipping damage is NOT covered by wa…

2, CAUTION: Do not attempt to bend conduit or pipe other than 1 ⁄ 2" through 2" IMC, EMT, rigid steel or aluminum. Bending other materials will damage the bender and void the warranty. NOTE: All operations referring to “toward the operator” are viewed from the lifting handle e…

3, 6. When bending 1 ⁄2" - 1" conduit the upper roller and support arm must be positioned between the shoe and the roller housing. Position the urethane roller by moving the roller housing against the frame stop and removing the pin. 7. Lift the roller support arm to cl…

4, 3. Check the bending shoe to be sure the correct grooves for the conduit being bent are facing toward the operator. If the shoe must be rotated, hold the pendant control Return button and press the jog button until the zero light goes out. The shoe will rotate 180° then stop in the load position. S…

5, 10. To bend more conduit of the same material and at the same angle, load and secure as described in steps 3 through 6. To bend the same type conduit but at a different angle, load and secure; turn angle set knob to the desired angle, then press the bend button. 11. Bending different type…

6, Gardner Bender B2000 Cyclone Gardner Bender RPS-0097 rA 01/06 PO Box 3241 • Milwaukee, WI 53201-3241 • 414-352-4160 • Fax 414-352-2377 6615 Ordan Drive • Mississauga, Ontario L5T 1X2 • 905-564-5749 • Fax 905-564-0305 5.0 ANGLE ADJUSTMENT Two different type scales are mounted on the shoe outer rim.…