Alcorn Mcbride RidePlayer Operation & User’s Manual

43, 43 September 14, 2018 SYNCHRONIZATION Sync Inputs GPS In (Serial Port – 12-pin Molex) PTP In – IEEE-1588 (Primary Control Port - M12 X-Coded) NTP In (Primary Control Port - M12 X-Coded) Genlock In - Blackburst, C-Sync, Tri-level (BNC) SMPTE LTC In (6-Pin Molex) …

28, 28 September 14, 2018 DIGITAL INPUTS This connector provides access to 8 discrete digital inputs that can be used as show control triggers. Each input has two contacts and can be software-configured for two modes of operation; contact closure or voltage. Connector Information Conn…

31, 31 September 14, 2018 PRECISE TRIGGERING No matter how perfectly locked clocks may be, it doesn’t do much good if you can’t start playback at the same time. To illustrate by example, let’s walk through a typical dark ride system that requires synchronized on-board audio and off-bo…

18, 18 September 14, 2018 SYSTEM MENU • Device ID – Shows the user-assigned name of the RidePlayer unit (i.e. “RV1”) • Version – Firmware version of unit • Build – Build revision of firmware • Status – View status info such as temperature, fan speed…

41, Alcorn Mcbride RidePlayer 41 September 14, 2018 MOUNTING RidePlayer is designed to be flush-mounted to a flat surface. It has two removable brackets that can be relocated to mount the unit in two different configurations; side mounted and end mounted. This allows for the conservation of vertical or horizontal s…