Beacon S242P Operation & User’s Manual

15, Beacon S242P S242P User Manual 15 8.2 D-SUB 15 PIN CONNECTOR Pin Signal Pin Signal Pin Signal 1 Red video 6 Red ground 11 Ground Shorted 2 Green video 7 Green ground 12 Data (SDA) 3 Blue video 8 Blue ground 13 H. Sync 4 Ground 9 5V 14 V. Sync 5 GND 10 Ground…

8, S242P User Manual 8 l QUICKLY STARTING Note: Be sure that the power switches of both the computer and the monitor are OFF. l CONNECTING THE CABLES Put the signal cable into the back of the monitor connector, then plug the other end into the computer's display interface. As shown …

11, S242P User Manual 11 l TROUBLESHOOTING If a problem persists even after applying the suggested remedies, contact a dealer. Problems Points to check with Possible Solutions 1. No picture Indicator status: Off Check that the power cord is correctly connected. If the problem persists, turn of…

7, S242P User Manual 7 l INTRODUCTION S242P is a professional full HD surgery medical image display used in the operating room with the characteristic such as high definition and high brightness. This product is with precise calibration and completely compliant with standard o…

3, S242P User Manual 3 l SAFETY SYMBOLS & PRECAUTIONS l SAFETY SYMBOLS Medical displays are mainly used to provide trained medical staff with professional digital images, thus for the professional reading and analysis. This manual uses the safety symbols below. They den…

6, S242P User Manual 6 FCC Warning: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference …