Baumer NE230 Operating Instructions Manual

33, Baumer NE230 NE230 www.baumer.com 33 4 Operating mode The device consists of an operator- and a programming level. The operation and use of the counter are described in this section. ● As soon as the power supply has been switched on, the counter is automatically set to the operating mode. In th…

3, NE230 www.baumer.com 3 Der Betrieb ausserhalb der angegebenen Beschreibungen/Parameter ist nicht bestimmungsgemäss und kann in Verbindung mit den zu steuernden/überwachenden Anlagen/Maschinen/Prozessen zu - tödlichen Verletzungen, - schweren Gesundheitsschäden, - Sachschäden o…

28, NE230 28 www.baumer.com Litz contact only by means of connector sleeves with insulating enclosures for reasons of shock protection according to EN 61010. Do not otherwise assign contacts that have been left unassigned ex factory. We recommend to screen all sensor terminal leads and to grou…

40, NE230 40 www.baumer.com 6 Operating modes The operating modes are described below. Step preset The preselections are always handled in the sequence P1, P2 after each reset. When the first preselection P1 is reached, there is no automatic reset. When the second preselection P2 …

32, NE230 32 www.baumer.com Display test ● The display test is automatically carried out when proceeding the test routine (as described above). The individual segments are tested first digit by digit and then altogether. After completion of the display test the next test (keypad test) c…

42, NE230 42 www.baumer.com Operating mode: Line 22 to 2 = Parallel comparison Reset mode: Line 29 to 2 with automatic reset RESE T VW (P2) VW (P1) O OUT P1 OUT P2 Operating mode: Line 22 to 3 = Schlepp- vorwahl VW (P1) corresponds to the interval between P1 and P2. When P2 is changed,…