Asante FAST 100 TX Operation & User’s Manual

18, Page 2-11 AsantéFAST 100 TX Managed Hub User’s Manual Figure 2-10 SNMP Parameter menu SNMP Read and Write Community By default, the SNMP Read Community is set to PUBLIC. To change the Read Community: 1 Type r from the SNMP Parameter menu. 2 Type a new community at the prompt. 3 …

5, iv Statistics Menu.....................................................................................2-18 Display Segment Counters...................................................2-18 Display Group Counters......................................................2-20 Display Port Counter…

7, Page 1-2 Introduction About This Manual This manual provides detailed information on the AsantéFAST 100 TX Man- aged Hub’s SNMP management capabilities; it describes the commands that are available and provides instructions on using the Command Line Interface. ▲ Important: Please refer …

3, Copyright Notice Copyright 1997 by Asanté Technologies, Inc. All rights reserved. No part of this manual, or any associated artwork, software, product design or design con- cept, may be copied, reproduced or stored, in whole or in part, in any form or by any means mechanical, e…

2, AsantéFAST 100 TX Managed Hub User’s Manual Asanté Technologies, Inc. 821 Fox Lane San Jose, CA 95131 February 1997 …

35, Asante FAST 100 TX Index ii H help. See technical support hubs compatible with Managed Hub 1-1 stacking 1-1 humidity, relative range A-1 I ID/MAC address, viewing 2-5 idle time out, Telnet 2-15 in-band management, accessing 2-1 installation instructions 1-2 IP (Internet Protocol) address mapping …