Anaheim Automation DPN10601 Operation & User’s Manual

42, September 2012L010155 42 / - Thumbwheel Index Enabled Format: /[0 or 1] Description: This command will either enable or disable the ability to use the thumbwheel switches for indexing. If enable, SW2 must be in the TWS position for the thumbwheel to be connected to the processor.…

31, September 2012L010155 31 Goto Command allows the program to jump to the specied label. Label Command inserts a label for go to and loop commands. Return from Subroutine Command will return to the last goto and execute the next line of code. Outer Loop Command allows a sequence of c…

36, September 2012L010155 36 ED - Encoder Delay Format: ED[value] Description: This command sets the wait time a specied number of milliseconds after a relative index or absolute move is nished, before reading the encoder. This is used to remove the ringing that might be associated wit…

19, Anaheim Automation DPN10601 September 2012L010155 19 The SMC60WIN software is a handy utility that supports Anaheim Automation’s line of DPN10601’s step motor controllers. Connecting your PC to the DPN10601, via a serial cable, the SMC60WIN software can easily perform the following tasks: • Exercise and …

33, September 2012L010155 33 PPS -> RPS Convert from pulses per second to revolution per second. RPS ->PPS Convert from revolution per second to pulses per second. Steps Per Rev Enter the number of steps per revolution of the step motor. The default is for a 200 step/rev motor in half step, whic…

26, September 2012L010155 26 Analog Max Speed Input Sets the analog speed input feature on or off. Set Speed Lower Limit Send the analog speed lower limit to the controller. Set Speed Upper Limit Send the analog speed upper limit to the controller. Set Analog Speed Sets the max speed …