AMF-BRUNS AL1 Operating Instructions Manual

46, Fine Adjustments Page 46 of 76 Linear Lift AL1 If the edge is not in contact with the ground:  Raise the platform slightly.  Place a wooden beam, a pallet or similar item under the platform, in the area of the roll-off guard.  Lower the platform once again, until…

43, Faults and Troubleshooting Linear Lift AL1 Page 43 of 76 Fault (possible) Cause Remedial Measures The Linear Lift folds out but does not lower. The remote control is defective. Check the remote control and it’s connections. Replace the remote control if necessary…

18, Description Page 18 of 76 Linear Lift AL1 2.2 Rating Plate A rating plate, which contains the fundamental data, is at- tached to the Linear Lift (see Figure 6). The rating plate is located on the floor anchorage. Figure 6: Rating Plate Year of manufacture Serial number …

58, Fine Adjustments Page 58 of 76 Linear Lift AL1  Release the “UP” push-button (1) as soon as the plat- form stops at the embarkation / disembarkation level.  Check that the abrasion protectors on both elbow joints are firmly in contact with the carrier arms, such that the…

29, AMF-BRUNS AL1 Operation Linear Lift AL1 Page 29 of 76  Press and hold the “DOWN” push-button on the remote control (2). The Linear Lift lowers the platform to the ground. The roll- off guard folds down CAUTION! Risk of injury when lowering the platform. W hen the platform is lowered…

25, Operation Linear Lift AL1 Page 25 of 76 W ARNING! Danger through road traffic collisions. A number of risks are involved for passengers and opera- t or when using the Linear Lift on public highways. Therefore: W hen the parking the vehicle ensure that other road traffi…