APAR AR500 Operating Instructions Manual

13, 13 output signal). Manual operation is available for the analog output of the meter and is programmed using parameters 9: outA , chapter 10, Table 10. Also, the output can be configured for quick (unconditional) manual mode controlled by the BIN binary input, by programming parameter 15: Func …

3, 3 1. SAFETY PRINCIPLES  before you start to use the device, become familiar with the present instructions;  in order to avoid electrocution or damage to the device, its mechanical and electrical installation must be performed by qualified staff;  before switching on the power supp…

2, 2 Thank you for choosing our product. These instructions will facilitate operating the device and enable safe use of the controller at its full capacity. Prior to the installation and startup of the device, please become familiar with these instructions. In the event of any add…

7, APAR AR500 7 the equipment. In AR500 and AR503, the PRG input is accessible from the top of the enclosure. Place the adapter in the opening in the enclosure with the USB socket facing the nearest wall of the enclosure. b) connection of a 2- and 3-wire transducer (Iout - output current, Uout - output…

8, 8 b) button functions in the parameter configuration menu and the quick access menu (chapters 10 and 11) Button Description [and marking in the contents of the instructions] [SET] : - edits the current parameter (the value blinks on the display) - approves and save…