Anleaf Technologies AP300W Operation & User’s Manual

3, Equipment Introduction: 1. Logic Chart for Solar Power Box and PV Panel 2. Main Components: 2.1. The solar power panel applies to 12VDC energy storage battery system. 2.2. PV charge/discharge controller owns 12VDC/25A input and 12V/30A output. 2.3. Built-in constant current …

4, Efficiency ≧85% 85% % Overload / Short circuit protection Circuit control with self-recovery fuse YES Overload ability 100%≦Load≦500% for 3S; 500%≦Load 1S 3 S DC Output DC output Cigarette lighter socket 9.6VDC~14.60VDC/6A max 12 VDC DC plug 24…

7, 2. Instantaneous over-load The total output of solar power bank is 300W with two AC output sockets. If the two AC outputs gets the value of loads which are more than 150 watts meanwhile, the protection system will auto-cutoff the electric power to protect the inverter. The solution is to run 1…

1, Anleaf Technologies Co., Ltd. No.68-6, Zhongxiao Street, Tuku Township, Yunlin County 63359, Taiwan website: www.anleaf.com.tw / e-mail: [email protected] USER GUIDE Portable Solar Power Generator Model : AP300W …

6, Anleaf Technologies AP300W 2.1. High Power Storage Battery If the LED indicates green light, the power of battery shows in full level and the voltage is above 12.6V usually. 2.2. Low Power Storage Battery If the LED indicates yellow light, the battery power shows in low level, then user can choose the DC outp…

5, 5. Turns on the electric power without a load, please note that the high voltage still runs on AC outlet. 6. Please avoid the environment of high temperature when the battery is using. 7. Do not un-screw the solar power box except the qualified engineer. 8. To avoid the water or anything into…