A.H.Beard Genius Owner's Manual

13, 11 You may now connect your headboard to the attachment plates using the remaining short bolts and nuts to secure it to the brackets. The heads of the bolts will face outward. Use a 9/16" socket and 1/2" wrench to tighten the bolts. STEP 2 STEP 3 Attach the plastic spacer an…

8, 6 To install the legs, thread the washer over the bolt of the leg with the recessed side facing the leg, and tighten by hand. Do not over tighten. STEP 1 STEP 2 Always use two people when setting up the base. Place the bed base box in a desired location with the bottom of the box fac…

12, 10 STEP 1 a.) Align the hole in the bracket to the brass sleeve into which the leg threads. Hold the bracket in place and screw the leg into the base until it is snug. DO NOT OVERTIGHTEN. Too much force may cause the leg to spin freely. b) Align the tab with the hole in th…

15, 13 Remove back cover from remote control. Remove and replace batteries. Press and hold button on the back of the remote. The light will begin to flash then become a continuous solid light. Both lights on the Power Down Box and the Remote will be continuous, then simultaneously tur…

10, 8 For customer support, visit www.ahbeard.com or call: 1300 654 000 STEP 14 Basic setup is now complete! See page 9 for remote control operating instructions. Locate the mattress retainer bar brackets. Slide the left side of the mattress retainer bar into the bracket. Pull the ret…

14, A.H.Beard Genius 12 In the event that the base is stuck in an articulated position during a power outage- the Power Down Box will return the base to a flat position. (2) 9 Volt batteries are required to operate the power down feature and are NOT included. Locate the Power Down Box under the base. Press and h…