4D systems gen4-uLCD-43 D Quick Start Manual

1, www.4dsystems.com.au What’s included?  gen4-uLCD-43 (D/DT/DCT)  gen4-Interface Board  30-way Flat Flex Cable (FFC) gen4-uLCD-43 D/DT/DCT 4.3” Slim Intelligent Display Module with embedded DIABLO16 Processor and Resistive or Capacitive Touch Panel Supporting Documents Datasheet…

2, Page 2 of 6 QUICK START GUIDE LET’S GET STARTED REQUIREMENTS: To connect this module to a computer, you need the supplied FFC and gen4-IB (Interface Board) as well as the 4D Programming Cable or uUSB-PA5-II (Programming Adaptor). Alternatively, you can use the supplied FF…

3, 4D systems gen4-uLCD-43 D Page 3 of 6 QUICK START GUIDE Power Up and Connect to a Computer Using gen4-IB & uUSB-PA5-II 1) Connect one end of the FFC to your module’s 30-way ZIF socket with the metal contacts on the FFC facing up on the latch. 2) Connect the other end of the FFC to the 30-way ZIF socket on the …

4, Page 4 of 6 QUICK START GUIDE Power Up and Connect to a Computer Using gen4-PA 1) Connect one end of the FFC to your module’s 30-way ZIF socket with the metal contacts on the FFC facing up on the latch. 2) Connect the other end of the FFC to the 30-way ZIF socket on the gen4-PA* …

5, Page 5 of 6 QUICK START GUIDE Start Using Workshop4 IDE 1) Open Workshop4 IDE and create a new project. 2) Select the display module you’re using from the list. 3) Select your desired orientation for your project. 4) Click next. 5) Choose a WS4 Programming Environment. Only th…

6, Page 6 of 6 QUICK START GUIDE Follow steps 6b.1 to 6b.4 to scan and detect your display module 6b.1) Click on the COMMS tab, select the COM port the display module is connected to from the dropdown list. 6b.2) Click on the RED Dot to start scanning for the display module.…