Adamson IS Series Operation & User’s Manual

7, Page 7 Adamson Systems Engineering | IS118 User Manual When flown in the same array as an IS7, all IS118 presets contain the inherent delay needed to be properly phase- aligned. When flown separately or ground stacked, IS118 subs should be phase-aligned to the IS7 array using measurement soft…

4, Page 4 Adamson Systems Engineering | IS118 User Manual In an effort to continuously improve its products, Adamson releases updated accompanying software, presets and standards for its products. Adamson reserves the right to change the specications of its products and the content of…

2, • Distribution Date: June 1st, 2018 • Copyright 2019 by Adamson Systems Engineering Inc.; all rights reserved This manual must be accessible to the person operating this product. As such, the product owner must store it in a safe place and make it available upon request to a…

6, Page 6 Adamson Systems Engineering | IS118 User Manual The IS118 is paired with Lab.gruppen D-Series ampliers. Maximum quantities of the IS118 per amplier model are shown below. For a master list, please refer to the Adamson PLM & Lake Handbook, found on our website. Use …

3, Adamson IS Series Page 3Page 3 Adamson Systems Engineering | IS118 User Manual 1. Safety & Warnings 2. Product Introduction 3. Wiring & Amplication 4. Presets & Control 5. Acoustic Data 3 4 5 7 8 ______________________________________________________________________________________…

5, Page 5 Adamson Systems Engineering | IS118 User Manual The IS118 (992-0010) comes with 4x Neutrik Speakon™ NL4 connections, wired in parallel. The 2 rear connections pass pin 1 +/- to the driver and the 2 front connections pass pin 2 +/- to the driver. The IS118b (992-0011) comes with an ex…