ADAMS RITE eForce 150 Installation Instructions And User Manual

10, 10 80-0180-307, Rev A NOTE: Step 6 is performed to configure a Model 3090-01 for a RIM exit device using 8700/8800 Exit Devices. 6. On the back side of the exit device, REMOVE only the lower Phillips head screw, depending on hand of door, to free up the cylinder actuator for …

44, 44 80-0180-307, Rev A Adams Rite 10027 S. 51st St. Ste 102 Phoenix, AZ 85044 Tel: 1-800-872-3267 Mon-Fri: 6:00am - 4:00pm PDT Fax: 1-800-232-7329 www.adamsrite.com © 2015, Hanchett Entry Systems, Inc., an ASSA ABLOY Group Company. …

23, 23 80-0180-307, Rev A NOTE 1: Supervisor Code must be 4–7 digits. NOTE 2: After Step e, there will be green LED flash and 2 short tones. e. ENTER new Supervisor Code and then #. NOTE: After Step f, there will be green LED flash and 2 short tones to indicate successful Su…

14, 14 80-0180-307, Rev A Figure 17 Mounting the eForce 150 1. INSERT the properly dimensioned spindle into the output hub. NOTE: The eForce 150 must sit flush on the door surface. 2. MOUNT the eForce 150 onto mounting bracket and GUIDE the spindle into the cam …

17, ADAMS RITE eForce 150 17 80-0180-307, Rev A Programming Information 1. PERFORM the following to enter the programming mode. a. PRESS and HOLD the # key until the yellow LED flashes three times. b. RELEASE the # key and the yellow LED will begin to flash continually. NOTE: At the end of each prog…

28, 28 80-0180-307, Rev A NOTE: Completing the following programming section does not include resetting User Codes. Reset All Features to Default Values 1. PERFORM the following to reset all features to factory default values. NOTE: Yellow LED will blink continuously during programming. a. …