DURKOPP ADLER 867 Service Instructions Manual

14, Adjust eccentric The eccentric 3 has to be adjusted in such a way that the open side 4 of the eccentric slot superimposes the screw 2. – Loosen screw 2. – Through the hole 1, turn the eccentric 3 in such a w ay that the open side 4 of the eccentric slot be oriented to the screw 2. – …

6, DURKOPP ADLER 867 Index Page: 2.12 Thread-guiding parts ............................................ 36 2.12.1 Thread regulator ............................................... 36 2.12.2Threadtake-upspring............................................ 37 2.13 Bobbin winder............................................…

56, 2.16 Potentiometer in the arm Sewing machines with thread cutter are equipped with a potentiometer in order to limit the driving speed of higher sewing foot strokes. Through this potentiometer the control recognizes the sewing foot stroke and limits the driving speed. 2.16.1 Basic se…

35, 2.9 Stitch length limitation Depending on the sewing equipment used, the stitch length setting has to be limited to 6, 9 or 12 mm. – Unscrew the screw 2 on the stitch length setting wheel. – Lift off the setting wheel 1. – Unscrew the set screw 4 and screw it into the corre…

23, 2.5 Needle bar linkage 2.5.1 Align the needle bar linkage laterally Caution: Danger of injury ! Turnthemainswitchoff! Check and set the needle bar linkage only w ith the sewing machine switched off. Standard checking The needle must penetrate the center of the feed dog’s stitch hole. – Insert…

38, 2.11.2 Height of the sewing feet arrested with hand lever Caution: Danger of injury ! Turnthemainswitchoff! Check and set the sewing foot lifting only with the sewing machine switched off. Standard checking The sewing feet 4 are arrested in lifted position with the hand lever 1 for example in…