Holars AS H-TAG Operation & User’s Manual

6, 5 STANDALONE MODE H-TAG can be worked as Standalone Reader for single door. (Factory default mode)---8 0 # Connection Diagram Common Power Supply: Access Control Power Supply: Door Bell Connect H-TAG H-TAG …

10, 9 Set Strike-out Alarm The strike-our alarm will engage after 10 failed card attempts (Factory is OFF). It can be set to deny access for 10 minutes after engaging or disengage only after entering a valid card/PIN or Master code. Programming Step Keystroke Combination…

2, 1 CONTENTS INTRODUCTION ………………………………… 2 INSTALLATION ………………………………… 4 STANDALONE MODE ………………………… 6 CONTROLLER MODE …………………………11 WIEGAND READER MODE ……�…

9, 8 Set Relay Configuration The relay configuration sets the behaviour of the output relay on activation. Programming Step Keystroke Combination 1. Enter Program Mode * (Master Code) # 2. Pulse Mode OR 2. Toggle Mode 3 (1-99) # (factory default) The r…

1, Holars AS H-TAG H-TAG Access Controller / Reader User Manual www.holars.no – www.holars.se …

7, 6 Attention: Install a 1N4004 or equivalent diode is needed when use a common power supply, or the keypad might be damaged.(1N4004 is included in the packing) Programming Programming will vary depending on access confirguration. Follow the instructions according t…