Hirschmann iFLEX TRS 14 Operation & User’s Manual

32, Configuration 5.7 Setting the angle range (angle sensor only) If an angle sensor is connected, this function is used to define the type of sensor being used. Follow the procedure described below in order to adjust the angle range. 1. Open the housing of the iFLEX TRS 14 as de…

3, Tables and illustrations Table 1 Overview of wireless sensors ................................................................. 10 Table 2 Overview of status LED .......................................................................... 19 Table 3 Overview of signal ranges .........…

24, Configuration 5.1 Overview of functions Function selection Display from to Register wireless sensor … to channel 1 LED 1, green, flashes 3 6 … to channel 2 LED 2, green, flashes 6 9 … to channel 3 LED 3, green, flashes 9 12 … to channel 4 LED 4, green, fl…

30, Configuration 5.5 Adjusting the zero point (load/angle sensor only) If load and angle sensors are connected, this function can be used to make subsequent small cor- rections to the zero point. Follow the procedure described below in order to adjust the zero point. 1. Open th…

27, Hirschmann iFLEX TRS 14 Configuration 5.3 Deleting wireless sensors Wireless sensors that are not to be used any longer must be deleted and deactivated by removing the batteries. Follow the procedure described below to delete a wireless sensor. 1. Open the housing of the iFLEX TRS 14 as describe…

8, Safety instructions 1.1 EU conformity declaration © 2010 Hirschmann Automation and Control GmbH · Branch Office Ettlingen · E-mail: [email protected] 8/37 21-810-19-0003_421830_en (Rev A).doc / 2010-08-31 / Issue A / rk. …