HEIDENHAIN TNC 426 PB/M Technical Manual

866, December 2001 Operands 7 – 17 MP4110.0-47 Timer preset value T0 to T47 Input: 0 to 65 535 [PLC cycle times] T16 T64 MP4110.16 T17 T65 MP4110.17 T18 T66 MP4110.18 T19 T67 MP4110.19 T20 T68 MP4110.20 T21 T69 MP4110.21 T22 T70 MP4110.22 T23 T71 MP4110.23 T24 T72 MP4110.24 T25 T73 MP4…

514, HEIDENHAIN TNC 426 PB/M 6 – 184 HEIDENHAIN Technical Manual TNC 426, TNC 430 6.12.3 Analog and Digital Closed-Loop Spindle Control For both analog and digital output of the nominal speed command you can program speeds from 0 to 99 999.999 rpm. The maximum controllable spindle speed is: If in MP3010 you have selected th…

92, 3 – 10 HEIDENHAIN Technical Manual TNC 426, TNC 430 Logic unit LE 426 PB, LE 430 PA * 40 40 40° 215 40 30 83 307 °C * °C °C B R 331 * * * * * °C °C °C °C >577 >110 80 80 40 40 30 100 160 30 100 °C * Air inlet Measuring point for ambient temperature Free spa…

413, December 2001 Tilting Axes 6 – 83 6.5.6 Automatic Compensation of Offset for Tilting Axes Unlike the “tilted working plane,” here the coordinate system is not tilted. With M114 or M128, the TNC compensates the offset of the tool that results from tilting the axes. The tool…

323, December 2001 Overview of Markers and Words 5 – 13 M 4180 Rapid traverse programmed (FMAX) NC NC 6 – 237 M 4181 NC program selected NC PLC 280 476-01 6 – 245 M 4182 AUTOSTART active NC NC 280 476-17 6 – 247 M 4183 Time from AUTOSTART expired NC NC 280 476-17 6 – 247 M 4200 Overflow during…

792, 6 – 462 HEIDENHAIN Technical Manual TNC 426, TNC 430 6.24 Commissioning 6.24.1 Preparation Proceed as follows: 7 77 7 Check the wiring against the grounding diagram and the safety concept (See ”Basic Circuit Diagram” at the end of Chapter 3). 7 77 7 Check the control-is-ready function. (…