InSinkErator Model SS-200 Installation Manual

2, InSinkErator Model SS-200 2 Table of Contents Introduction Introduction .................................................................................... 3 Clean the Drain Line ....................................................................... 3 Typical Installation ............................…

9, 9 ELECTRICAL SHOCK • Turn off the electrical supply to the disposer before servicing. Test the circuit with a voltmeter or circuit tester to ensure the power is off. • Installation must conform to all local electrical codes. • All control centers and disposers must be groun…

8, 8 Standard Motor Connection Wiring Diagrams NOTE: The diagrams below show standard motor connection wiring for a manual switch operation. For alternate controls, please refer to the control panel installation manual. 4 5 6 MOTOR LEAD WIRE# L2 2 L1 7 31 L1 L2 L3 1 4 10 5 6 12 MOTO…

6, 6 Standard InSinkErator Mountings 1. Place the mounting flange (1) over the existing collar adaptor connection lip or sink bowl flange (this may require some force). 2. Push the mounting flange up out of the way and fit the groove in the mounting gasket (2) onto the connection lip. Make sure…

3, Introduction 3 INTRODUCTION The InSinkErator Foodservice food waste disposer is UL ® and CSA ® Listed when installed in conjunction with InSinkErator mounting adaptors and controls (see Figure 1 for typical installation). See Table 1 (page 4) for the approved disposer/ mounting adaptor …

7, 7 PROPERTY DAMAGE These plumbing instructions were written for an experienced competent installer. If the installer is not experienced in plumbing installation, InSinkErator recommends that competent professional assistance is sought. Damage to the disposer or accessories as a …