Infoblox NT-4000 Installation Manual

26, Appliance Component Replacement 31 Infoblox Installation Guide Note: The replacement IB-Type 3 disk assembly part number is IB-4000-R2-DISK-HDD300. Disk Array Guidelines Infoblox designs the disk array to be completely self managed. No maintenance procedures are required for a n…

22, Initial Network Automation Appliance Configuration 21 Infoblox Installation Guide Scan Port IPv6 Default Gateway: DNS Server 1: 10.102.3.50 DNS Server 2: 10.102.3.10 — Edit these settings? <y/n> [n]: 11. If you accept the settings, enter n. — Configure the system with these settings…

9, For the Network Automation NT-4000 Appliance 9 Figure 4 Network Automation NT-4000, Rear View with RJ-45 Gigabit Ethernet Ports Table 3 Rear Panel Components Component Description IPMI Port Reserved for future use. Port is active but unsupported. Console Port A male DB-9 serial…

7, For the Network Automation NT-4000 Appliance 7 Table 1 Front Panel Components Disk Drive Front Panel LEDs The disk drives are located on the appliance front panel. To the right of each drive, two LEDs display connection and activity status. Table 2 lists the disk drive LED combina…

13, Infoblox NT-4000 For the Network Automation NT-4000 Appliance 12 Installing the Network Automation NT-4000 Note: The Network Automation NT-4000 system must be installed in a four-post seismic rack. The Network Automation NT-4000 appliance ships with mounting rails, side rails, and an accessory kit that contains �…