Lamina Nixie Clock Lamina Nixie Operation Manual

22, Lamina Nixie Clock Lamina Nixie - 23 - Place the box to a clean area and remove velcro strips start from the top rear side Remove the 4 screws around the lower side of the box with the supplied 2.5mm hexagonal key Take o the lid and the paper cover Hold the body of the box and lift it up carefully The clock is…

6, - 7 - To the clock’s settings enter the parameter menu. To do this, press and hold the SET button for 3 beeps and release. When you enter in the parameters menu, rst you see the rmware versions of the clock. The numbers start: eg.: 00 -1 24. This value can not be modi…

14, Further color settings: Tube color mode I. parameter #20: day mode color, day light period set in parameter #4 and #5 parameter #21: night mode color, night light period set in parameter #4 and #5 Tube color mode II. parameter #22: AM tube color, from midnight till noon. parameter #23:…

20, Explanations of the parameter settings menu 15 - If the value is “0” the clock will not show the date automatically. If it is “1” , the date will show automatically in every 1 minutes, if it is: ”2”, then in every 10 minutes, at value “3” in every hour. 16 - When …

23, - 24 - Lift up the tray by its front side and remove the bottom rear screws, the clock is still attached to the base by the front screws Now hold the clock in place with your ngers, while lifting up the front of the tray and remove the front screws Loosen the last screw, but keep it in place…