ASROCK P55 EXTREME Installation Manual

15, 15 2.6 Deleting RAID Volume If you want to delete a RAID volume, please select the option Delete RAID Volume, press <Enter>, and then follow the instructions on the screen. Please note that you are only allowed to create one RAID partition at a time under BIOS RAID environment.…

13, 13 Vo l u m e0 If you selected RAID 0 (Stripe), use the up or down arrow keys to select the stripe size for your RAID 0 array then press <Enter>.The available values range from 8 KB to 128 KB. The default selection is 128 KB. The strip value should be chosen based on the planned…

14, ASROCK P55 EXTREME 14 Vo l u m e0 Press <Enter> under the Create Volume item. The utility prompts a confirmation message as below. Vo l u m e0 Press <Y> to complete the setup of RAID. After the completion, you will see the detailed information about the RAID that you set up. …

10, 10 If you want to use “Intel Matrix Storage Manager” in Windows ® environment, please install "SATAII driver" from the Support CD again so that “Intel Matrix Storage Manager” will be installed to your system as well. …

1, 1 Guide to SATA Hard Disks Installation and RAID Configuration 1. Guide to SATA Hard Disks Installation ............................ 2 1.1 Serial ATA (SATA) Hard Disks Installation ............... 2 2. Guide to RAID Configurations ......................................... 3 2.1 I…

5, 5 2.2 RAID Configurations Precautions 1. Please use two new drives if you are creating a RAID 0 (striping) array for performance. It is recommended to use two SATA drives of the same size. If you use two drives of different sizes, the smaller capacity hard disk will be the base storage size for …